Evident LogoOlympus Logo

Excitation and Barrier Filters in Fluorescence Microscopy

This tutorial explores how excitation and barrier filters can be interchanged to permit a wide spectrum of specific wavelengths for imaging fluorescent samples. Detailed instructions on how to operate the tutorial are given below.

There are two sliders that control the wavelengths passed by the excitation and barrier filters. These can be adjusted by using the mouse cursor to move them back and forth, changing the wavelength. The bandwidth slider controls the width the band of wavelengths passed by the excitation filter, and has a range from 1 percent to 15 percent. Alternatively, you can select from pre-arranged filter combinations (used by Olympus microscopes in their filter cubes) by changing the cube code in the pull-down menu. Bandwidths for each filter cube combination are given to the right of the pull-down menu. Keep in mind that there are some combinations of wavelengths selections for the barrier and excitation filters that do not allow any light to pass through into the observation tube.

Contributing Authors

Mortimer Abramowitz - Olympus America, Inc., Two Corporate Center Drive., Melville, New York, 11747.

Matthew J. Parry-Hill and Michael W. Davidson - National High Magnetic Field Laboratory, 1800 East Paul Dirac Dr., The Florida State University, Tallahassee, Florida, 32310.

Sorry, this page is not
available in your country.

Sorry, this page is not available in your country