DP20 firmware update

How to update the DP20 firmware

1. Introduction
   This document explains how to update the DP20 firmware.
   ^* The update program is different for the DP20 and DP20-5. Before downloading the program, check the model number of your digital camera.
2. What you need for the update procedure
   • A Compact Flash (CF) card to which the relevant update program has been copied
   • DP20
   • External monitor to connect the DP20

   Caution Do NOT do any of the following, otherwise a malfunction or failure may occur: - Unplug the AC adaptor from the DP20 or unplug the power cable from the AC outlet. - Turn off the DP20 during the update process. - Remove the CF card inserted into the DP20.

3. How to update the firmware
   [[1] Turn off the DP20 and connect the external monitor.
   [2] Insert the CF card containing the update program into the DP20.
   [3] While pressing and holding the [EXPOSE] button and the "Cross-Cursor button (▲) ", turn on the DP20. Keep pressing the buttons until the update screen appears on the monitor.
   
   [4] When the above update screen appears, release the buttons to start the update process. (It takes about 15 seconds.)
   [5] The process is completed when "-FLASH WRITE COMPLETED" is displayed (on two lines).
   During the update process, the CARD LED on the DP20 controller will be lit; it will go off when the process is completed.
   
   [6] Confirm that the "-FLASH WRITE COMPLETED" message is displayed, then turn off the DP20.
   [7] Remove the CF card from the DP20.
   [8] Click here to make sure your DP20 was properly updated.

Note: The various settings of the DP20 will not be affected by the update.